Monogram ZGU385N Manuel du propriétaire télécharger pdf (Page 8)

Installation Preparation

POWER SUPPLY LOCATIONS

Gas supply:

These cooktops are shipped from the factorg set

for either natural gas or LP gas. Check to be sure

SOU have the correct cooktop for the tgpe of gas

being used.

• The pressure regulator must be connected in series

with the manifold of the cooktop and must remain

in series with the supplg line regardless of tgpe of

gas being used.

• The natural gas model is designed to operate at

S" water column pressure. A regulator is required

at the natural gas source to provide a minimum

of 6" water column to the cooktop regulator.

• The liquid propane model is designed to operate at

!0" water column pressure. A regulator is required

at the LP source to provide a minimum of :!1" water

column to the cooktop regulator.

Maximum inlet pressure for the regulator supplied

with the cooktop is 14" water column regardless of

the gas being used.

For ease of installation, and if local codes permit,

the gas supplg line into the cooktop should be 1/2"

or 3/4" ID flexible metal appliance connector, three

to five feet long.

NOTE: Purchase new flexible line. DO NOT USE OLD,

PREVIOUSLY USED FLEXIBLE LINE.

• Make gas connection through rear wall, or on

cabinet floor at rear, as illustrated.

1. Install the house gas supplg at least !" from

the back wall.

2. Locate the electrical outlet !2" below the

countertop.

Gas

supply

line

Install a manual shut-off valve in the gas line in an

easilg accessible location outside the cooktop. Be

sure SOU know how and where to shut off the gas

supplg to the cooktop. Install the electrical outlet

!2" below the countertop.

Electrical supplg:

This cooktop features pilotless electric ignition for

energg savings and reliabilitg. It operates on a 120 volt,

60 Hz power supplg. A separate circuit, protected /jointfilesconvert/296571/bg a

!5 amp time delag fuse or circuit breaker, is required.

Optional Combination Installations

This cooktop mag be installed in combination

with a ZVB36 Monogram Downdraft Vent, a ZET1

or ZET938 Single Oven or a ZTD910 or ZKD910

Warming Drawer.

• The gas and electrical supplg must be located

where it will not interfere with vent housing, the

oven or the warming drawer. Review pages 12

to 14 for additional installation requirements.

• A properlg-grounded 3-prong receptacle should

be located within reach of the cooktop's four-foot

power cord.

IMPORTANT: (Please read carefully). FOR PERSONAL

SAFETY, THIS APPLIANCE MUST BE PROPERLY

GROUNDED.

The power cord of this appliance is equipped with

a three-prong (grounding) plug which mates with a

standard three-prong grounding wall receptacle to

minimize the possibilitg of electric shock hazard

from this appliance.

The customer should have the wall receptacle and

circuit checked /jointfilesconvert/296571/bg a qualified electrician to make sure

the receptacle is properlg grounded and has correct

polaritg.

Where a standard two-prong wall receptacle is

encountered, it is the personal responsibilitg and

obligation of the customer to have it replaced with

a properlg grounded three-prong wall receptacle.

Do Not, Under Any Circumstances, Cut Or Remove

The Third (Ground) Prong From The Power Cord.

Do not use an extension cord.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Monogram ZGU385N Manuel du propriétaire Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Cuisiniers Monogram ZGU385N