Monogram WX08X10025 Manuel du propriétaire Page 26

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 29
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 25
17
STEP 10A (continued)
Custom Handles
• If you are using custom handles, the handle must be
properly secured to the overlay panel before sliding
the panel into the trim.
• The cabinet manufacturer will supply the custom
handle and hardware.
• Discard the supplied handle.
• Remove the trim. Peel away a few inches of the
adhesive backing.
IMPORTANT: Tape is very sticky and strong. Once it
adheres to a surface, it cannot be removed without
damaging both surfaces. Do not install the trim before
the final wood panels are in place. Be sure to align the
trim carefully before removing the paper backing.
Reinstall all original screws.
• Reinstall the handle side trim using all 12 supplied
flat-head screws, plus the 12 flat-head screws
originally installed in the handle trim.
• Install a supplied end cap onto the top of the door
using a Phillips head screwdriver and 2 screws
provided. Hand-tighten screws into end caps. Do not
overtighten; damage will occur.
• Clean the aluminum trim with rubbing alcohol –
do not use alcohols with oil or lanolin that will
prevent adhesion of double-sided tape.
• Slip aluminum cover trim behind the top end cap to
check fit. The aluminum cover trim has a recess on
each end which fits the end cap.
Installation Instructions
Top End Cap Fits
Over the Aluminum
Trim. Secure Cap
with 2 Screws.
End Cap
STEP 10A (continued)
• Carefully place the aluminum cover trim into top
end cap so that the recess is aligned with the cap.
Use the top to bottom grooves along the handle side
to align the cover trim accurately. Pull tape a few
inches at a time while pressing the trim against the
door. Press and hold approximately 10 seconds
before continuing along the length of the door.
• Install another end cap at the bottom of the door
to secure the cover trim. Use a stubby Phillips head
screwdriver and 2 screws provided.
NOTE: Make sure there are no gaps in the installation.
• Follow the same procedure on the opposite door.
Insert
Aluminum
Trim Into
End Cap.
Cover Trim
End Cap
Vue de la page 25
1 2 ... 21 22 23 24 25 26 27 28 29

Commentaires sur ces manuels

Pas de commentaire