Monogram ZVC30LSS Spécifications télécharger pdf (Page 14)

Installation Preparation

REMOTE MOUNTING OF THE CONTROL

(WIRED)

WARNING: Disconnect electrical

power from unit before beginning remote control

installation. Failure to do so could result in personal

injury or damage to the electrical controls.

AVERTISSEMENT : Il faut

débrancher l’alimentation électrique de l’appareil

avant de commencer l’installation de la commande

à distance. Il faut suivre cette directive pour éviter

des blessures ou endommager les commandes

électriques.

REMOTE LOCATION FOR CONTROL

The control can be removed from the hood and

installed in a backsplash or countertop.

• A cover plate is provided to cover the opening in

the hood when the control is removed.

• A 30-ft. length of 4-wire cord is supplied to

accommodate most installations. Because only

30-ft. of cord is provided, careful consideration

must be given to the location of the remotely

mounted control.

NOTE: Not for telecommunication (telephone)

network.

• The cord must be routed through the holes in the

insert sleeve, and the rubber grommets put into

place around the cord.

NOTE: On the ZVC30 and ZVC36 models, the cord

needs to be routed through the holes in the insert

sleeve before the damper plate is installed.

• Route the cord through the conduit to reach the

installation location of the control.

1-11/16″

3-11/16″

Control cutout

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Pas de commentaire

Monogram ZVC30LSS Spécifications Page 14